3D Card Using My Craft Studio Bejewelled by Kath W
You will need:
- My Craft Studio Bejewelled download (jewellery 021 image)
- Scissors
- 3D Glue Gel
- Craft Master 250gsm Pure Print
- Construction acetate
- Double-sided tape
-
- Step 1 Increase 021 jewellery image in MyCraftStudio to approximately 6×6” so that you can fit two on the page. Print onto Craft Master 250gsm Pure Print paper three times.
-
- Step 2 Start by cutting 2 of the large images out completely.
-
- Step 3 Cut another image, this time cut the outer edge (gold) and the diamonds off.
-
- Step 4 Cut the inner flower, the centre jewels, and finally the very centre gem.
-
- Step 5 Add glue gel to the back of the largest image, stick on top of the other, offsetting it slightly.
-
- Step 6 Add the remaining layers in the same way, from largest to smallest, and leave to dry.
-
- Step 7 Cut construction acetate to 4 x 4”, score along the top 1” down, and add double-sided tape. Attach to the back of the card by lining the two pieces together, removing the tape, and sticking together.
Your card should now stand. Add a sentiment and your card is complete!
I hope you enjoy this tutorial! Happy crafting from Kath W 😊
Leave a Reply
Want to join the discussion?Feel free to contribute!